工业滑升门厂家自主设计安装
大背筋工业滑升门实例

工业滑升门 Industrial lift sliding door
旭日工业滑升门和车库门
Rising Sun industrial lift sliding door and garage door
1、旭日环照滑升门门板材料选用双热镀锌压花钢板,表面压有均匀的柱状条纹,芯部材料为聚氨酯,门板的背板内设有钢制加强带。使其具有平整,美观、高强度、抗腐蚀和保温性。动力系统选用国产、进口品牌工业门开门机,运行速度快、低噪音、寿命长等特点。工业滑升门在开启时沿着轨道向上以垂直提升、90度翻转滑动到天花板下、以及45度倾斜提升,不占用屋内大量自有空间。使滑升门完全敞开。使其几乎能适应每种建筑物的外门使用。
Industry lift sliding door is made of double-layer hot-dip galvanized embossed steel plate, and the even columnar stripe is pressed on the surface; the core materials are polyurethane; the back plate of door panel is equipped with the steel reinforcing band. Make it smooth, beautiful, high-strength, corrosion-resistance and temperature-keeping. Power systems use domestic and imported industrial opener with fast operation, low noise, long life, etc; lift sliding door opens along the track up to 90 degrees turning vertical lifting, sliding to the ceiling, and a 45 degree incline lifting, does not occupy the indoor large private space. Make the door open completely and can be applied to all kinds of building.

2、全透明铝制滑升门,门板由铝合金和聚碳酸酯玻璃组成,具有高透光性。广泛用于汽车4S店、设备展厅、大型商场等建筑物。采用德国原料的聚碳PC板,厚3mm-5mm两种,根据门宽及窗宽来选择,有良好的抗紫外线功能,其抗冲击力是钢化玻璃的100倍。门板均可选用多种标准颜色,并有多种防夹手功能。
2、Fully transparent aluminum lift sliding door: Door panels are made of aluminum alloy and polycarbonate glass with high transmittance. It is widely used in auto 4S shop, equipment exhibition hall, large shopping mall and other buildings. Polycarbonate PC board uses the raw materials from German,two kinds of thickness, 3mm-5mm, according to the width of doors and windows. It has a good UV resistance and its impact resistance is 100 times that of tempered glass. The door has a variety of colors to choose and a variety of hand anti-clipping functions.
门板尺寸范围:宽度:12000mm 高度:12000mm
Door dimensions: width: 12000mm height: 12000mm
门板厚度:40mm、45.51mm 热阻系数 R=14.96,18.25
Door thickness: 40mm, 45.51mm thermal resistance coefficient R = 14.96,18.25
发泡密度:48kg/m³±2kg/m³

翻板滑升门
垂直滑升门

Foam density: 48kg / m³ ± 2kg / m³
表 面:门板表面聚脂处理,颜色有白色、蓝色、杏仁色、褐色、银色。(其他颜色可定制)
Surface: the surface of the door is polyester. Color: white, blue, almond, brown, silver. (Other colors can be customized)
轨 道:有2英寸(51mm)和3英寸(76mm)轨道两种,全部采用1.5-3mm厚的热镀锌钢板制成。有标准轨、低轨、高提升轨、垂直提升轨和斜棚提升轨。
track specs: two type of inches (51mm)and 3 inches (76mm)are all using 1.5-3mm hot-dipped galvanized steel plates ,including standard lift ,low lift ,high lift ,vertical lift and roof pitch lift track
平衡系统:外置高品质扭簧平衡系统,扭簧工作寿命达50,000~100,000次工作循环。
Balance system: a high-quality built-out torsional spring balance, the service life of which reaches up to 50000-100000 times of working cycles.
密 封:底部U形乙烯树脂密封条,防冻,防潮和防水渗入,侧边、顶部,带槽密封条密封,门板间连接处,以凸凹槽及热隔断管或条密封。
Sealing: bottom: U-shaped ethylene resin, anti-freeze, damp proof and water proof; the side and top have sealing trips with slot, and the connection point between door panels is sealed by concave and convex slot and heat insulation pipe;

通道小门:根据需要在门体宽度小于5500mm时,可以选配多种尺寸的通道小门。
Small doors of passengers: width of the door is less than 5500mm as required with a variety of sizes to choose from.
观察小窗:根据需要可以选配多种尺寸的观察窗口。
Small observed windows: a variety of sizes to choose.
门体抗风载荷:门体关闭状态抗风载450N/㎡
Wind resistance load: 450N /㎡ in off state.
阻燃试验达到等级:B1
Heat resisting coefficient: B1
隔音性能:R=22分贝/db
Sound insulation: R = 22 dB / db
工业开门机:马斯特、旭日环照等多种型号的工业开门机
Industrial opener: Masterton, Sun Rising Huanzhao and other various types of industrial openers.
功 率:250W,330W等
Power: 250W, 330W, etc.
驱动电压:单相220V±5%和三相380V±5%,50Hz
Drive voltage: single phase 220V ± 5% and three-phase 380V ± 5%, 50Hz .
电 流:单相1.7A,三相0.8A

翻板滑升门
翻板保温滑升门配合堆积门

Current: single-phase, 1.7A, three-phase 0.8A
传动方式:直接轴传动和间接链传动
Transmission mode: direct shaft drive and indirect chain drive.
输出扭矩:单相50Nm-90Nm,三相60Nm-300Nm
Output torque: single-phase 50Nm-90Nm, three-phase 60Nm-300Nm.
最大门体重量:单相350Kg,三相700Kg
Maximum weight of the door: 350Kg single phase, three-phase 700Kg.
限位方式:机械与电子
Limiting way: mechanical and electronic
电机转速:1400RPM
Motor speed: 1400RPM
运行速度:133mm/s(UN18612标准)
Operating speed: 133mm / s (UN18612 standard)
启动次数:100次/24小时
Starting number: 100/24hours
工作温度:-25℃~+60℃

Operating temperature: -25 ℃ ~ +60 ℃
减速方式:齿轮
Way of deceleration: Gear
手动操作:采用操纵链实现机械与电器离合,进行手动操作。亦可实现快速拉链手动操作。
Manual operation: mechanical and electrical clutch through manipulating the chain. Can also be manually operated by quick zipper operation ban also be realized.
无线遥控功能:提供快捷、方便的无线控制。
Wireless remote control functions: to provide fast, convenient wireless control.
擎动方式:机械式擎动。
Dynamic way: mechanize
工业用轴承支架:可以承载负荷运转
Industrial bearing bracket: operating with load
控制箱:24VAC,单键控制OPEN/CLOSE/STOP,紧急停止开关电子锁。
Controller: 24VAC, one-touch control of the OPEN / CLOSE / STOP, emergent stop of electronic switch lock .
安全控制装置:可选配安全气囊保护装置,红外安全保护装置
Safety control devices: use safe air chamber protection device and infrared safety device